Filter
Top Products
9840 Operator Panel
9840 Tape Drive Operations Guide—429596-002
2-9
Operator Panel Display
DatCrFail1 Unable to create (format) a data
tape
Ensure tape is write-enabled.
Try another drive.
If persistent, refer to Forcing a
Diagnostic Dump (Reset Drive) on
page A-4.
DmpCrFail1 Unable to create (format) a dump
tape
Ensure tape is write-enabled.
Try another tape.
Try another drive.
If persistent, refer to Forcing a
Diagnostic Dump (Reset Drive) on
page A-4.
DmpCrFail2 Unreadable tape format Reclaim as data tape.
Retry operation.
Try another tape.
If persistent, refer to Forcing a
Diagnostic Dump (Reset Drive) on
page A-4.
DumpToHost Dump or event log is being
transferred to the NonStop
system: operation panel switches
are locked
No action is necessary.
DmpWrFail1 Unable to write dump to tape
Unable to position on tape
Try another tape: ensure tape is
formatted for dump.
DmpWrFail2 No dump to process Force a dump: Refer to Forcing a
Diagnostic Dump (Reset Drive) on
page A-4.
DumpAgain? Tape drive detected the same
CHK (FSC) within one minute
Refer to DumpAgain? Message
on
page A-3.
Exp ClCart Cleaning cartridge is used up Replace the cleaning cartridge.
FFFF:Dmp Y Alternates with corporate ID at
completion of IPL, where
FFFF=FSC of last dump date
collected, Y=number of
uncollected dumps in EEPROM
Optionally move dumps to the
NonStop system or tape: refer to
Forcing a Diagnostic Dump (Reset
Drive) on page A-4.
Fix_CfgErr Upon IPL, configuration checksum
does not match
Refer to Fix_CfgErr Error
on
page A-1.
INIT (FSC) Initialization error Reset the tape drive by performing
an IPL.
If that fails, contact your service
provider to replace the tape drive.
Table 2-4. Operator Panel Messages
Display Probable Cause Recommended Action