Filter
Top Products
Installing and Configuring the Tape Drive for the
NonStop NS-Series Server
9840 Tape Drive Operations Guide—429596-002
C-8
Configuration
The fiber cable is a multimode/short wave fiber optic cable. This cable is normally
an orange color.
11. Power on the 9840 tape drive. See Figure C-6 for the power switch location. Then
wait for it to perform its power-on-self-test (POST).
12. Power on the router, and then wait for it to perform its power-on-self-test (POST).
Configuration
1. In SCF, issue this command:
SCF> ADD TAPE $tape, SENDTO STORAGE, LOCATION (group, module,
slot), SAC sac-id, PORTNAME 64-bit-portname, LUN lun-id
Example:
SCF> ADD TAPE $TAPE1, SENDTO STORAGE, LOCATION (110,2,3), SAC
1, PORTNAME 100000E00C00F000,LUN 1
Table C-2. Fiber Cables
Connector Fiber Cable Fiber Cable Distance
LC - LC 50/125 µm 2-300 meters (6.56-984.25 feet)
LC - LC 62.5/125 µm 3-150 meters (9.84-492.13 feet)
Note. The LUN in SCF should be 1 for the tape drive that is on bus 0. The LUN in SCF should
be 3 for the tape drive that is on bus 1.
Note. PORTNAME in SCF corresponds to the WWP name of the router. This name is located
on the back of the device.
Figure C-8. Rear View of the Fibre Channel to SCSI Router
WWNN: 100000E00200F000
WWPN: 100000E00C00F000
ENET MAC ID: 00:E0:02:00:00:XY
WWN Name
WWP Name
Ethernet MAC ID
(Physical Address)