Filter
Top Products
23
Display Contents
COPY INHIBIT
REC INHIBIT
A. DUB INHIBIT
(REC TAB)
A. DUB INHIBIT
(48K)
A. DUB INHIBIT
(LP)
A. DUB INHIBIT
(BLANK)
A. DUB INHIBIT
(DV)
A. DUB INHIBIT
(NTSC/PAL)
A. DUB INHIBIT
(DVCAM)
OPERATION
LOCK
The user attempts to record signals protected with the copy guard.
The user attempts to record on a write protected cassette tape.
(The rear slide is pushed to SAVE.)
The user attempts to perform audio dubbing on a write protected cassette tape.
(The rear slide is pushed to SAVE.)
This message is displayed when audio dubbing is attempted under the following con-
ditions:
• The AUDIO MODE item of the AUDIO/VIDEO menu is set to 48k.
• The tape is recorded with a sample frequency of 48kHz.
The user attempts to perform audio dubbing on a tape recorded in the LP mode.
The user attempts to perform audio dubbing on a blank tape.
The user attempts to perform audio dubbing during DV signal input. (The INPUT SEL
switch is set to DV)
This message is displayed when the signal system is changed during audio dubbing
(NTSC or PAL).
The user attempts to perform audio dubbing on a DVCAM format tape.
This message is displayed when a button on the unit is pressed while the OPERA-
TION LOCK function is engaged (ie, the OPERATION item of the SYSTEM (2/2) menu
is set as ON).
Ⅵ Warning display : When anomalies occur in the VTR, warning messages with error
codes will be displayed.
32K CH–1/2
SP
000
min
W
ARNING 7001
DRUM MOTOR FAI LURE
04/01/02 STANDBY
-
OFF
11:20:00 TCR 02:00:00:00
Warning display
For details, please
refer to page 66,
“Warning Display”.
22
ON-SCREEN DISPLAY
–
Alarm display
–
Ⅵ Alarm display : Alarm messages are displayed as shown below, when an operation
error has occurred or when the unit is in a poor condition for operation.
E.g., dirty head.
Display Contents
LOW VOLTAGE
HEAD CLEANING
REQUIRED!
OVERHEATING!
The voltage of the DC input power is low. Continued operation will bring the unit to the
Operate OFF mode.
The video head is dirty. Please clean it with the dedicated head-cleaning tape.
(
☞
Page 8)
If the head is clogged, it will be detected in the PLAYBACK mode and displayed.
When the unit enters the STOP mode or the cassette is ejected, the display goes off.
The temperature inside the unit has exceeded the regulated value. Please disconnect
the power and place the unit in a cool place. If this message is displayed again, dam-
age may have occurred. Please consult with your JVC-authorized service agent.
32K CH–1/2
SP
000
min
HEAD CLEANING REQUIRED!
NO DV SIGNAL
0 4/01/02 STANDBY
-
OF
F11:20:00 TCR 02:00:00:0
A
B
Ⅵ Display at position A : Displays which show the state of the unit (and which are not set
via the DISPLAY mode) continues to be displayed here until the
conditions are rectified.
Display Contents
INVALID TAPE!
LP TAPE!
NO DV SIGNAL
Data tapes for PC use or DVC PRO tapes has been inserted. The cassette will be
ejected.
The user attempts to play back a tape recorded in the LP mode.
This unit cannot record or play in the LP mode.
The user attempts to record without DV signal input.
Ⅵ Display at position B : Messages indicating operation errors are displayed for about 3
seconds.
They are displayed when the DISPLAY mode is ON or AUTO.