2-50
Cisco MDS 9000 Family NX-OS Interfaces Configuration Guide
OL-29284-01, Release 6.x
Chapter 2 Configuring Interfaces
Verifying Interfaces Configuration
Example 2-15 Displays Interface Information in a Brief Format After the System Default Switchport
Mode F Command is Executed
switch# show interface brief
-------------------------------------------------------------------------------
Interface Vsan Admin Admin Status SFP Oper Oper Port
Mode Trunk Mode Speed Channel
Mode (Gbps)
-------------------------------------------------------------------------------
fc4/1 1 F -- notConnected swl -- --
fc4/2 1 F -- notConnected swl -- --
fc4/3 1 F -- notConnected swl -- --
fc4/4 1 F -- notConnected swl -- --
fc4/5 1 F -- sfpAbsent -- -- --
fc4/6 1 F -- sfpAbsent -- -- --
fc4/7 1 F -- sfpAbsent -- -- --
fc4/8 1 F -- sfpAbsent -- -- --
fc4/9 1 F -- sfpAbsent -- -- --
Example 2-16 Displays Interface Information in a Brief Format After Two Interfaces Are Individually
Configured for Mode FL
switch# show interface brief
-------------------------------------------------------------------------------
Interface Vsan Admin Admin Status SFP Oper Oper Port
Mode Trunk Mode Speed Channel
Mode (Gbps)
-------------------------------------------------------------------------------
fc4/1 1 FL -- notConnected swl -- --
fc4/2 1 F -- notConnected swl -- --
fc4/3 1 FL -- notConnected swl -- --
fc4/4 1 F -- notConnected swl -- --
fc4/5 1 F -- sfpAbsent -- -- --
fc4/6 1 F -- sfpAbsent -- -- --
fc4/7 1 F -- sfpAbsent -- -- --
fc4/8 1 F -- sfpAbsent -- -- --
fc4/9 1 F -- sfpAbsent -- -- --
fc4/10 1 F -- sfpAbsent -- -- --
Displaying TL Port Information
The show tlport command displays the TL port interface configurations. This command provides a list
of all TL ports configured in a switch and shows the associated VSAN, the FC ID for the port (only
domain and area are valid), and the current operational state of the TL port (up or initializing). See
Example 2-17 through Example 2-20.
Example 2-17 Displays the TL Ports in All VSANs
switch# show tlport list
-------------------------------
Interface Vsan FC-ID State
------------------------- ------
fc1/16 1 0x420000 Init
fc2/26 1 0x150000 Up
TL ports allow a private device (devices that physically reside on the loop) to see a fabric device and
vice-versa by proxying fabric devices on the loop. Fabric devices are proxied by allocating each fabric
device an ALPA on this loop.
