22
Operating Error
If the scan tool freezes, then an exception occurs or the vehicle’s ECU (Engine
Control Unit) is too slow to respond to requests. You’ll need to do the following to
reset the tool:
• Press and hold the POWER button for at least 2 seconds to reset the scan
tool.
• Turn the ignition ‘off’ and wait for about 10 seconds. Turn the ignition back to
‘on’ and continue the testing.
Scan tool doesn’t power up
If the scan tool won’t power up or operates incorrectly in any other way, you’ll
need to do the following to check it:
• Check if the scan tool’s OBD II connector is securely connected to the
vehicle’s DLC;
• Check if the DLC pins are bent or broken. Clean the DLC pins if necessary.
• Check vehicle battery to make sure it has at least 8.0 volts.
4. Review Data
The Review Data function allows viewing of data from the last test recorded
by the scan tool.
1)Use the UP/DOWN scroll button to select Review Data from Main Menu, and
press ENTER.
3/
Diagnostics
DTC Lookup
? Review Data ?
Print Data
System Setup
Tool Information
