Filter
Top Products
Messages and how to react to them
The following messages may be displayed by your navigation system. Refer to the table below to
identify the problem, then take the suggested corrective action.
There are occasions when you may see error messages other than those shown here. In such a
case, follow the instructions given on the display.
Messages for navigation functions
Message Cause Action (Reference)
Route calculation wasnot
possible.
Route calculation hasfailed be-
cause of amalfunction in map data,
software, or hardware.
! Change thedestinatio n.
! Consultthe Pioneer Localdealer if thismes-
sage persists.
Route calculation notpossi-
ble: destination istoo far.
The destination istoo far. Set a destination closerto the starting point.
Route calculation notpossi-
ble: destination istoo close.
The destination istoo close. Set a destinationfarther from the starting
point.
Route calculation notpossi-
ble: navigation cannotbe pro-
vided around destinationor
starting point.
The destination, waypoint(s), or
starting point arein an area where
no road exists(e.g. a mountain) and
the route calculationis impossible.
! Set adestination and waypoint(s) onroads.
! Resetthe destination after you drive the ve-
hicle to anyroad.
Route to destinationcannot
be calculated.
The destination or waypoint(s) arein
an isolated island,etc. without a
ferry and the routecalculation isim-
possible. If there isno road con-
nected to yourstarting point or
destination, this messagewill ap-
pear.
Change the destination.
Failed to makethe route pro-
file.
In rare cases,a route calculation
error may occur.
! Retry.
! Consultthe Pioneer Localdealer if thismes-
sage persists.
No picturefolder. Save jpeg
file to /Pictures/folder
Cannot load theimage because
“Pictures” folder isnot found in the
inserted external storagedevice.
Use appropriate dataand store it correctly.
(Page 165)
“Pictures” folder existson the SD
memor y card but thereis no load-
able data inthe folder.
Use appropriate dataand store it correctly.
(Page 165)
Data Read error. Failed to read thedata for some rea-
son.
Use appropriate dataand store it correctly.
(Page 165)
The file iscorrupt The datais damaged or an attempt
was made toset an image filethat
was not madeto specifications as
the splash screen.
Use appropriate dataand store it correctly.
(Page 165)
En
198
Appendix
Appendix