Filter
Top Products
p Both rear speaker leads output and RCA
rear output are switched simultaneously in
this setting. (When you use the product
without RCA rear output, this setting only
applies to the rear speaker leads.)
p “Rear SP” can be set only when the source
is selected to “Off”.
1 Display the “AV System Settings”
screen.
= For details,refer toDisplaying the screen for
AV system settings on page 170.
2 Touch [Rear SP].
Each touch of [Rear SP] changes the settings
as follows:
! Full
When no subwoofer is connected to the
rear output, select “Full”.
! Sub. W
When a subwoofer is connected to the rear
output, select “Sub. W”.
Switching the muting/
attenuation timing
You can mute the AV source volume or attenu-
ate the output signal.
p Even if this setting is “Off”, the navigation
system will mute or attenuate the AV
source volume when the mute signal is out-
put via MUTE lead.
1 Display the “AV System Settings”
screen.
= For details,refer toDisplaying the screen for
AV system settings on page 170.
2 Touch [Mute].
Each touch of [Mute] changes the settings as
follows:
AVIC-Z130BT
! Guide/Tel/VR: The volume is muted or atte-
nuated according to the following condi-
tions.
— When the navigation outputs the gui-
dance voice.
— When you use a cellular phone via
Bluetooth technology (dialing, talking,
incoming call).
— When the voice recognition mode is ac-
tivated.
! Tel/VR: The volume is muted or attenuated
according to the following conditions.
— When you use a cellular phone via
Bluetooth technology (dialing, talking,
incoming call).
— When the voice recognition mode is ac-
tivated.
! Off: The volume does not change.
AVIC-X930BT, AVIC-X9310BT
! Guide/Tel: The volume is mutedor attenu-
ated according to the following conditions.
— When the navigation outputs the gui-
dance voice.
— When you use a cellular phone via
Bluetooth technology (dialing, talking,
incoming call).
! Tel: The volume is muted or attenuated
when you use a cellular phone via
Bluetooth technology (dialing, talking, in-
coming call).
! Off: The volume does not change.
p AV source volume returns to normal when
the corresponding action ends.
Switching the muting/
attenuation level
You can select the muting/attenuation level of
“Mute”. This setting is also effective for a
mute signal that has been received from the
MUTE lead connected to the navigation unit.
p This menu is not available when AV source
is “Off”.
1 Display the “AV System Settings”
screen.
= For details,refer toDisplaying the screen for
AV system settings on page 170.
2 Touch [Mute Level].
Each touch of [Mute Level] changes the set-
tings as follows:
En
172
Chapter
32
Customizing preferences