Filter
Top Products
/ -'[eliJ :| liB:_,,,_-"[oIo]l i J_[_
SYMPTOM CAUSE REMEDY
This unit does not operate The internal microcomputer has hecu frozen. Turn oil the power of this unit and then turn on again after
properly, about one minute (P.14).
There is rotation noise of The tmnperature inside this unit rises. The lan starts to rotate to cool oll the temperature inside
the l_m. this unit.
A noise occurs at the A very low fi'equency component mnong the hnprovmnent can be made by adding a short hJdedn or
change of the tracks that wow and flutter of the analog record is being fade-out to the track (P.64).
has been recorded from the output as a m)ise.
analog record and edited.
Rmnote control does not The batteries of the remote control are too Replace two batteries with new ones (P.I I ).
work. weak.
Remote control is from too far. Use the remote control within 6 in and 60 degrees radius
Remote control is being used at an incorrect (R I 1).
angle.
Direct sunlight or lighting (of an inverter type Change the position so that the remote control sensor is not
of fluorescent lamp, etc.) is striking the exposed to strong lighting.
remote control sensor.
TV does not correctly Remote control is being used near TV set Relocate this unit away from the TV or cover the TV's
fllnctiou wheu the renlote with a remote control seusor, remote coutrol seusol_
control is being used.
The picture on the TV is The indoor antenna is used. 1Jse an outdoor antenna, or set this unit away li'om the TV
impaired, set.
"o
"o
m
z
X