Filter
Top Products
9
Initial settings
The following settings are required before you
operate the unit for the first time, after replacing
the car battery, or changing the connection. If the
date or the time on the unit is not set correctly,
the HDD may trace the playback history
incorrectly.
1 Press the RESET button (page 8).
2 Attach the front panel (page 8).
3 Rotate the R dial to select AM Step
“9K” or “10K,” then press the R dial.
The AM (FM) tuning interval is factory-set to
“10K.”
If the frequency allocation system of your
country is based on 9 kHz (50 kHz) interval,
set to “9K.”
4 Set the date and time.
1Rotate the R dial to select the year,
then press the R dial.
2Rotate the R dial to select the
month, then press the R dial.
3Repeat steps 1 and 2 to set the
day, hour, minute.
The set date and time are displayed and the
clock appears.
When you set the date and time after
the initial settings
Press (MENU) and select “Time Set” in “Setup,”
then press the R dial.
Note
During the date and time setting, if Demonstration
display appears, press the R dial to display the date
and time setting display.
Tips
• The clock uses a 12-hour digital indication.
• The “AM” or “PM” indication is automatically
switched depending on the set hour.
• The indication for the day of the week changes
automatically according to the date.
• If you press (F1) in step 4, the cursor moves to the
previous item.
Deactivating the
Demonstration display
In the default setting, Demonstration is set to
“On” (to active the demonstration display). After
initial setting, you must set Demonstration to
“Off.”
1 Press (MENU).
2 Rotate the R dial to select “Display,”
then press the R dial.
3 Rotate the R dial to select
“Demonstration,” then press the R
dial.
4 Rotate the R dial to select “Off,” then
press the R dial.
5 Press (F3) ().
The normal display appears.