Filter
Top Products
60
Removing the unit
1 Remove the front cover
1Detach the front panel (page 8).
2Press the clip inside the front cover
with a thin screwdriver.
3Repeat step 2 for the other side.
2 Remove the unit
1Use a thin screwdriver to push in
the clip on the left side of the unit,
then pull out the left side of the unit
until the catch clears the mounting.
2Repeat step 1 for the right side.
3Slide the unit out of its mounting.
Precautions
• If your car was parked in direct sunlight, allow
the unit to cool off before operating it.
• Power antennas will extend automatically
while the unit is operating.
• Do not use the custom functions while driving,
or perform any other function which could
divert your attention from the road.
• Do not drop water or foreign objects on the disc
tray. If they enter the unit, a fire or malfunction
can occur.
If you have any questions or problems
concerning your unit that are not covered in this
manual, please consult your nearest Sony dealer.
Moisture condensation
On a rainy day or in a very damp area, moisture
condensation may occur inside the lenses and
display of the unit. Should this occur, the unit
will not operate properly. In such a case, remove
the disc and wait for about an hour until the
moisture has evaporated.
To maintain high sound quality
Be careful not to splash juice or other soft drinks
onto the unit or discs.
Notes on CD lens
• Do not touch the lens in the disc tray.
• Do not use a commercially available lens
cleaner.
If “LOW TEMP Warming Up” appears in
extremely cold environment
Recording and editing on the HDD cannot be
performed. In this case, warm up the car interior
with a heater and leave the unit for a while until
the unit can be operated again.
4 mm
(
3
/
16
in.)