Filter
Top Products
3-7
Nº51 Media Player Setup Menu
Outputs: Analog
Audio Preferences
Speaker Configuration (Setup : Audio : Outputs : Analog Audio Preferences :
Speaker Configuration)
Use the 5.1 option to configure the Nº51 Media Player to pass multi-
channel audio sources to the analog audio output connectors labeled
6 Channel Analog Outputs.
Use the 2-Ch Downmix option to configure the Nº51 Media Player to
downmix all multichannel audio sources to 2-channel before passing
them to the analog outputs.
• Two-channel and 2-channel downmixed audio streams are
output from the XLR and RCA analog output connectors as well
as the 6 Channel Analog Outputs connectors labeled R (right
front) and L (left front).
• The Crossover Configuration option is not available when using the
2-Ch Downmix parameter and appears grayed-out in the menu.
Crossover Configuration (Setup : Audio : Outputs : Analog Audio Preferences :
Crossover Configuration)
Crossover Configuration is used to assign independent crossover
points for each of the 6-channel audio output connectors. The table
below indicates default and possible crossover ranges for each
speaker parameter.
• Low frequencies are redirected from speakers with the highest
crossover points to speakers with the lowest crossover points.
• Low-frequency signals lower than the lowest crossover point are
redirected to the subwoofer.
• If the Subwoofer is set to None, LFE information is redirected to
the speakers with the lowest crossover setting.
• If the lowest crossover point is set to FULL, only LFE information
is redirected to the subwoofer.
• If Center is set to None, dialogue shifts to Front L/R.
Parameter Default Possible Settings
5.1 2-Ch
Front L/R 80 Hz Full Full, 30 to 120 Hz; in 10Hz steps
Center None Full, 30 to 120 Hz; in 10Hz steps, None
Surround L/R Full, 30 to 120 Hz; in 10Hz steps, None
Subwoofer Full, 30 to 120 Hz; in 10Hz steps, None
Setup Audio Outputs
HDMI Audio Preferences
SPDIF Audio Preferences
Analog Audio Preferences
Setup Audio
Outputs
Volume Control
A/V Sync Delay 0ms
Reset Audio Settings
Setup Audio Outputs Analog
Speaker Config 2-Ch Down...
Crossover Config
Speaker Distances
Levels Calibration