Filter
Top Products
1-10
Getting Started Mark Levinson
DO install the media player close to associated components to keep
interconnecting cables as short as possible.
DO select a dry, well-ventilated location out of direct sunlight.
DO allow at least 3 to 4 inches (8 to 10cm) of clearance above each
component for proper heat dissipation.
DO NOT place the media player on a thick rug or carpet or cover
the media player with a cloth, as this might prevent proper cooling.
DO NOT expose the media player to high temperatures, humidity,
steam, smoke, dampness, or excessive dust. Avoid installing the
media player near radiators and other heat-producing appliances.
DO NOT install the media player near unshielded TV or FM
antennas, cable TV decoders, and other RF-emitting devices that
might cause interference.
DO NOT place the media player on a windowsill or in another
location in which it will be exposed to direct sunlight.
DO NOT obstruct the IR (infrared) receiver/transmitter located on
the front-panel display. The remote control IR transmitter must be
in line of sight with the front panel display IR receiver/ transmitter
for proper remote control operation.
Caution! BEFORE moving the media player, make sure it is powered off with
the power button. Then, make sure the power cord is disconnected
from the ~ac mains connector and the electrical outlet.
Warning! MAKE SURE all components are properly grounded. Do not defeat
the safety purpose of polarized or grounding-type plugs with
“ground-lifter” or “cheater” adaptors. Doing so may cause
dangerous voltages to build up between components. The
presence of these voltages may result in personal injuries and/or
product damage.
Remote Control
Batteries
The remote control comes with two AAA alkaline batteries that
should be replaced as needed. Using alkaline batteries, which last
longer and do not leak, is recommended.
To install the remote control batteries:
1. Locate the battery compartment cover on the bottom of the
remote control (the end closest to the IR transmitter).