Filter
Top Products
3-4
Setup Menu Mark Levinson
Outputs: HDMI Audio Preferences (continued)
DTS (Setup : Audio : Outputs : HDMI Audio Preferences : DTS)
Use the DTS option to set the output behavior of a DTS-encoded
source when the Nº51 Media Player is using the HDMI connector.
To select an audio format:
Using the remote control up or down button, highlight the desired
setting, and press enter.
•Select Encoded if the associated component is compatible with
DTS-encoded sources. The Nº51 Media Player will pass DTS
signals directly to the associated component.
• Select PCM if the associated component cannot accept a DTS-
encoded audio format. The Nº51 Media Player will downmix DTS
signals to 2-channel PCM.
Enable (Setup : Audio : Outputs : HDMI Audio Preferences : Enable)
Use the Enable option to enable or disable the audio portion of the
rear-panel HDMI output port in the software.
When set to On, the three-position video output switch (rear panel)
must be set to HDMI to enable HDMI audio.
When set to Off, the audio portion of the HDMI output port is
disabled in the software even if the three-position video output
switch is set to HDMI. HDMI video output is not affected. If set to
Off, use the digital audio outputs or the analog audio outputs.