Filter
Top Products
20
6 MEMORY CHANNELS
INFORMATION CHANNELS
10 Information channels are available for storing
radio broadcasting service frequencies, such as
weather radio stations and community FM
broadcasting stations. For your conveniences,
pressing [INFO] instantly recalls the Information
channel to B-band. The following frequency data is
stored by default.
rebmuNlennahC
emaNyromeM/edoM/ycneuqerF
A6F-HT E7F-HT
1–I
/MF/zHM055.261
REHTAEW
)ytpmE(atadoN
2–I
/MF/zHM004.261
REHTAEW
3–I
/MF/zHM574.261
REHTAEW
4–I
/MF/zHM524.261
REHTAEW
5–I
/MF/zHM054.261
REHTAEW
6–I
/MF/zHM005.261
REHTAEW
7–I
/MF/zHM525.261
REHTAEW
8–I
/MF/zHM056.161
REHTAEW
9–I
/MF/zHM577.161
REHTAEW
0–I
/MF/zHM572.361
REHTAEW
You can revise the default channel data, such as the
receiving frequencies, modes, and memory names.
RECALLING AN INFORMATION CHANNEL
Press [INFO] to recall the Information channels.
• “I–n” appears, where “n” represents the
Information channel number from “0” ~ “9”.
• If the B-band is selected for operation, you can
turn the Tuning control or press [ ]/ [ ] to select
other Information channels. If the A-band is
selected for operation, press [A/B] to move the
operation band to the B-band and then select a
different Information channel.
• To exit the Information channel mode, press [A/B]
to select the B-band then press [VFO] or [MR].
Note: If you press [MN<->f], you can display the receiving frequency
in place of the memory name.
TH-F7E only: As default, no frequency data is stored in the
Information channel. Store the frequency data before using the
Information channels. Otherwise, an error beep sounds.
REPROGRAMMING THE INFORMATION CHANNEL
1 Press [VFO].
2 Select a desired frequency and mode.
3 Press [F].
4 Turn the Tuning control or press [ ]/ [ ] to select
the memory channel (I–0 to I–9) in which you want
to store the data.
5 Press [MR] ([ ] or [MNU]).
• A long beep sounds and the Information
channel data is now revised.
Note:
◆
When you perform the Full reset {page 50}, all the Information
channels recover the factory default values.
◆
If you clear an Information Channel data {page 16}, the factory
default value is recovered.
◆
You can also transfer the Information Channel data to the VFO
or another memory channel.