Filter
Top Products
25
7 SCAN
CALL SCAN
A Call channel can be stored for each amateur radio
band, such as the 2 m, 70 cm, and 1.25 m (TH-F6A
only) bands {page 19}. You can monitor one of these
Call channels and the current operating frequency
alternatively.
1 Select the frequency (in VFO, Memory Recall, or
Information Channel mode) you want to monitor.
• In VFO mode, press [A/B] to select the A or
B-band. Then, turn the Tuning control or press
[ ]/ [ ] to select the desired frequency.
• In Memory Recall mode, turn the Tuning
control or press [ ]/ [ ] to select a memory
channel you want to monitor.
• Press [INFO] to recall the last Information
Channel you monitored.
2 Press [CALL] (1 s) to start the Call Scan.
3 The Call channel for the band and the selected
VFO frequency, memory channel or Information
Channel are monitored alternately.
4 To stop the Call Scan, press [PTT] or [CALL].
Note:
◆
The transceiver stops scanning in all modes when it detects a
signal.
◆
You can perform the Call Scan even if the recalled memory
channel or Information channel has been locked out {page 27}.
◆
If the Call channel is not available for the current operating
frequency, an error beep sounds.
PRIORITY SCAN
You may sometimes want to check your favorite
frequency activities while monitoring the A and
B-bands. In this case, use the Priority Scan function.
It checks the activities of Pr1 and Pr2 channels every
3 seconds, alternately, using the B-band receiver.
If the transceiver detects a signal on Pr1 or Pr2, it
recalls the frequency to the B-band receiver.
Note: If you do not operate any control or key for 3 seconds after the
signal drops, the transceiver returns to the original frequency and
resumes Priority Scan.
PROGRAMMING PRIORITY CHANNELS
1 Press [VFO].
2 Turn the Tuning control or press [ ]/ [ ] to select
your desired priority channel frequency.
3 Select the mode and selective call functions, if
necessary.
4 Press [F].
• The memory channel number appears.
5 Turn the Tuning control or press [ ]/ [ ] to select
“Pr1”.
6 Press [MR] ([ ] or [MNU]) to store the data on the
priority channel.
• If you want to store a second priority channel,
repeat steps 1 ~ 6 and select “Pr2” in step 5.
Note: You can program any frequency available on the B-band as a
priority channel.
USING PRIORITY SCAN
1 Press [F], [BAL].
•“ ” appears.
• The transceiver checks for a signal on the Pr1
and Pr2 channels every 3 seconds, alternately.
• When the transceiver detects a signal on the
priority channel, “Pr1” or “Pr2” blinks and the
B-band frequency changes to the priority
channel.
• If you do not operate any control or key for
3 seconds after the signal drops, the
transceiver returns to the original frequency
and resumes Priority Scan.
2 To quit Priority Scan, press [F], [BAL] again.