Filter
Top Products
60
1.2 Setting Jumpers
When installing the unit to the server, a SCSI-ID must be set.
A SCSI-ID can be set using the short jumpers on the rear of the unit (the following diagram). Follow
"Installing Internal Options" in "User's Guide" in "PRIMERGY Document & Tool CD" provided
with the server to set a SCSI-ID.
The SCSI-ID can be set as shown in the following table.
` Do not change any jumper settings other than the SCSI-ID locations.
` Do not install jumpers horizontally.
SCSI-ID
Short jumper
0 1 2 3
0 OpenOpenOpenOpen
1 Short Open Open Open
2 Open Short Open Open
3 Short Short Open Open
4 Open Open Short Open
5
[*]
Short Open Short Open
6 Open Short Short Open
7 Short Short Short Short
8 Open Open Open Short
9 Short Open Open Short
10 Open Short Open Short
11 Short Short Open Short
12 Open Open Short Short
13 Short Open Short Short
14 Open Short Short Short
15 Short Short Short Short
*: Settings at the time of purchase
3
2
1
0
Not changeable
SCSI-ID
[Rear]