Filter
Top Products
60
GB
Problems and remedies (continued)
The sound skips.
• Wipe the CD clean (see page 64).
• Replace the CD.
• Try moving the system to a place without
vibration (e.g., on top of a stable stand).
• Try moving the speakers away from the system,
or placing them on separate stands.
When you listen to a track with bass sounds at
high volume, the speaker vibration may cause the
sound to skip.
Play does not start from the first track.
• With the system stopped, press PLAY MODE on
the remote repeatedly until “PROGRAM” or
“SHUFFLE” disappears to return to Normal
Play.
HD Recorder
Play does not start.
• There is no track on the HD.
• Moisture has condensed inside the system.
Leave the system turned off for about an hour.
• Press @/1 to turn on the system.
Album selection is not possible.
• You cannot select an album that contains no
tracks. Select an album that contains tracks.
The HD does not record.
• Make connections properly to an optional
component.
• Switch to a function other than HD.
• Adjust the recording level properly (see page
29).
• There has been a power failure or the power cord
has been disconnected during recording. Data
recorded to that point may be lost. Repeat the
recording procedure.
• Erase unnecessary tracks or albums to increase
the available space on the HD (see page 32).
• All the tracks on the CD are recorded on the HD.
• Switch Auto Storage mode off (see page 25).
The HD does not edit.
• Press PLAY MODE on the remote repeatedly
until “SHUFFLE” disappears.
The sound has a lot of static.
• Strong magnetism from a television or similar
device is interfering with operations. Move the
system away from the source of strong
magnetism.
Tuner
There is severe hum or noise (“TUNED” or
“STEREO” flashes).
• Set the proper band and frequency (see page 38).
• Connect the antenna properly (see page 10).
• Locate the antennas as far away from the main
unit and speakers as possible.
• Find a place and an orientation that provide good
reception, then set up the antenna again.
If you cannot obtain good reception, we
recommend you connect a commercially
available external antenna.
• The supplied FM wire antenna receives signals
along its entire length, so make sure you extend
it fully.
• Locate the antennas as far away from the speaker
cords as possible.
• Consult your nearest Sony dealer if the supplied
AM antenna wire has come off the plastic stand.
• Try turning off surrounding electrical equipment.
• Consult your nearest Sony dealer.
There is a severe hum or noise while recording
an AM radio station.
• Locate the AM loop antenna as far away from
the main unit and speakers as possible to
improve broadcast reception.
• Consult your nearest Sony dealer.
A stereo FM program cannot be received in
stereo.
• Press FM MODE on the remote until “MONO”
disappears from the display.
• See “There is severe hum or noise (“TUNED” or
“STEREO” flashes).”, and check the antenna
condition.