Filter
Top Products
27
GB
HD - Recording
Note
When recording a CD, track numbers are marked
when you paused recording. In addition, the tracks
might be recorded as the same single track with a
single track number when the same single track of the
same CD is recorded repeatedly.
• Any point during recording
(Track Mark)
You can mark track numbers during manual
recording of any source.
• After recording
Use the Divide function (see page 34).
This function is convenient when the source is
tape or radio programs and the track numbers
are not marked automatically.
Marking track numbers
automatically during recording
— Level Synchro Recording
The Level Synchro Recording function is
factory set to on, so the track numbers are
automatically marked. If “L-SYNC” does not
appear during recording, turn on the Level
Synchro Recording as follows. Track numbers
are automatically marked when the input signal
is continuously below a certain level for more
than 1.5 seconds and then exceeds that level.
1 Press FUNCTION repeatedly until “HD”
appears in the display.
2 While the system is stopped, press
MENU/NO on the remote.
“Edit Menu” appears in the display.
3 Press MENU + or – on the remote
repeatedly until “Setup?” flashes in the
display, then press ENTER/YES on the
remote.
4 Press MENU + or – on the remote
repeatedly until “T.Mark Off” (or
“T.Mark LSync”) appears in the display,
then press ENTER/YES on the remote.
5 Press MENU + or – on the remote to
select the setting, then press ENTER/
YES on the remote.
To
Turn on the Level
Synchro Recording
function
Turn off the Level
Synchro Recording
function
6 Press MENU/NO on the remote.
To proceed to recording, follow the
procedures about recording.
To change the trigger level for Level
Synchro Recording
When the Level Synchro Recording is set to
“On”, track numbers are automatically marked
when the input signal is below the trigger level
set in this section for more than 1.5 seconds
and then exceeds that level. The factory setting
is “–50 dB”.
When the recording source is tape or radio
program and the track numbers are not marked
properly because of noise, set this level higher
so that track numbers are marked easily.
Perform the following procedure to change the
signal level that triggers Level Synchro
Recording.
1 Press FUNCTION repeatedly until “HD”
appears in the display.
2 While the system is stopped, press
MENU/NO on the remote.
“Edit Menu” appears in the display.
continued
Select
T.Mark LSync.
(factory setting)
T.Mark Off.