Filter
Top Products
28
GB
Erasing blank portions
automatically
(Smart Space/Auto Cut)
The Smart Space function lets you make the
blank spaces between tracks 3 second long
automatically. If the Smart Space function is
on and there is no sound input for about 3
seconds or more (but less than 30 seconds)
during manual recording, the system replaces
this silence with a blank of about 3 seconds and
continues recording:
Auto Cut: When the Smart Space function is
on, if there is no sound input for 30 seconds or
more, the system replaces this silence with a
blank of about 3 seconds and enters recording
pause.
1 Press FUNCTION repeatedly until “HD”
appears in the display.
2 While the system is stopped, press
MENU/NO on the remote.
“Edit Menu” appears in the display.
Recording tips (continued)
3 Press MENU + or – on the remote
repeatedly until “Setup?” flashes in the
display, then press ENTER/YES on the
remote.
4 Press MENU + or – on the remote
repeatedly until “LS(T) –XXdB” appears
in the display, then press ENTER/YES
on the remote.
5 Press MENU + or – on the remote
repeatedly to select the level, then
press ENTER/YES on the remote.
You can set the level at any value between
–72 dB and 0 dB, in 2 dB steps.
6 Press MENU/NO on the remote.
Marking track numbers at a specific
point during recording
— Track Mark
You can mark track numbers at any time during
manual recording, regardless of the type of
sound source.
Press REC during manual recording at the
point you want to add a track mark.
The tracks following the added one are
renumbered.
Marking track numbers after
recording
Use the Divide function (see page 34).
Note
During Auto Storage or High-Speed Synchro Storage,
the Track Mark function does not function.
No sound input for 30 seconds or more
Off
Replaced with a blank of 3 seconds and
recording pauses
On
No sound input for less than 30 seconds
Off
Replaced with a blank of 3 seconds and
recording continues
On