Filter
Top Products
Helpful Hints
66
Operation Page
On the TV Page
On the unit’s display Page
Error messages
∫ Common
X HOLD ≥The Child Lock function is activated.
Press and hold [ENTER] and [RETURN] simultaneously until “X HOLD”
disappears.
62
∫ DVD
Cannot finish recording completely. ≥The programme was copy-guarded.
≥The disc may be full.
–
Cannot record on the disc.
Please check the disc.
Unable to format.
≥The disc may be dirty or scratched. 17
Cannot record. Disc is full. ≥Create space by erasing any unnecessary titles. [RAM]
≥Use a new disc. [RAM] [DVD-R]
29, 31
–
Cannot record. Maximum number of titles
recorded.
Error has occurred. Please press ENTER.
Timer Recording standby or Ext Link
standby will be canceled.
≥Press [ENTER] to start recovery process. You cannot operate the unit while it is
recovering (“SLF CHECK” appears on the unit’s display). –
No Disc ≥The disc is upside down. 17
Please change the disc. ≥There may be a problem with the disc. Press [< OPEN/CLOSE] on the main unit
to remove it and check it for scratches or dirt. (The unit turns off automatically
after you open the tray.)
17
This is a non-recordable disc. Cannot record.
≥The unit cannot record on the disc you inserted. Insert a DVD-RAM or unfinalized
DVD-R.
≥You inserted an unformatted DVD-RAM. Format the disc with this unit.
–
29
This disc is not properly formatted.
Formatting is necessary using DISC
MANAGEMENT.
≥The operation is prohibited by the unit or disc.
–
HARD ERR ≥If there is no change after turning the unit on and off, consult the dealer where the
unit was purchased.
–
NO READ ≥The disc is dirty or badly scratched. The unit cannot record, play, or edit.
≥You have used a DVD-RAM/PD lens cleaner and it has finished.
Press [< OPEN/CLOSE] on the main unit to eject the disc.
17
–
PROG FULL ≥There are already 16 timer programmes. Erase unnecessary timer programmes. 27, 55
REMOTE MODE ∑
(“∑” stands for a number.)
≥The remote control and main unit are using different codes. Change the code on
the remote control.
Press and hold [ENTER] and the
indicated number button at the same
time for more than 2 seconds.
11
SLF CHECK ≥The unit is starting up. Wait until the message disappears. –
U59 ≥The unit is hot.
The unit switches to standby for safety reasons. Wait for about 30 minutes until
the message disappears.
Select a position with good ventilation when installing the unit. Do not block the
cooling fan on the rear of the unit.
–
U99 ≥The unit fails to operate properly. Press [Í/I] on the main unit to switch the unit to
standby. Now press [Í/I] again to turn the unit on.
–
UNSUPPORT ≥You have inserted a disc the unit cannot play or record on. 15
VHSDVD
75VGN.book 66 ページ ２００４年７月２１日 水曜日 午前１１時５４分