Filter
Top Products
Advanced Operations
61
You can specify the position to start dubbing the programme
recorded on the disc to the tape.
≥The available discs for dubbing source are discs without copy
guard. Most of DVD-Videos are copy-guarded to prevent illegal
reproduction and they cannot be recorded with the following
procedure.
Preparation
DVD (Recording source)
≥Insert the disc containing the programme to be copied. (l 17)
VHS (Recording target)
≥Insert a video cassette with an intact erasure prevention tab.
(l 50)
≥Confirm that the remaining tape time is sufficient for recording.
(l 57)
Settings (“TV System” l 45)
≥When dubbing an NTSC disc to a tape
-
Set “TV System” on “Connection” in “SETUP” to “NTSC”.
≥When dubbing a PAL disc to a tape
-
Set “TV System” on “Connection” in “SETUP” to “PAL”.
[1] Press [DVD] and press [1, PLAY].
[2] Press [AUDIO] to Select the audio to be played
(the audio to be recorded) beforehand.
[RAM]
≥When the DVD-R is inserted, you cannot select the audio.
[3] Press [;, PAUSE] at the start point of the
recording.
[4] Press [VHS].
[5] Select “DC” channel with [CH, W, X].
≥The picture of the DVD is displayed on the TV.
≥When the “TP” channel is selected on DVD, you cannot select
the “DC” channel.
[6] Press [1, PLAY].
Start playing the video cassette and find the recording start point.
[7] Press [;, PAUSE] at the start point of the
recording, then press [¥, VHS REC] to pause.
Put the unit in the recording standby mode.
[8] Press [REC MODE] to select the recording
mode.
[9] Press [;, PAUSE].
≥VHS recording and disc play start at the same time.
∫When dubbing is started, the following operations also
start automatically
≥“On-Screen Messages” on Display ) “Off” (l 45)
Note
≥When “DVD / VHS Output” is set to “Manual” (l 43), or when DVD
output is selected in starting dubbing, the output is switched to VHS
automatically at the time when dubbing is started.
≥Switching the audio mode by pressing [AUDIO]. The audio which
you are hearing is recorded.
∫ Manual Dubbing (DVD l VHS)
To pause or stop Manual Dubbing
You cannot stop or pause on DVD and VHS at the same time
∫To pause or stop recording
Press [VHS] and press [;, PAUSE] or [∫, STOP].
∫To pause or stop play
Press [DVD] and press [;, PAUSE] or [∫, STOP].
∫About DC channel
(DC: Dubbing input channel)
When you select DC channel, VHS can receive the video/audio
signal from DVD. This enables you to dub the video played back
on DVD to VHS.
≥Press [VHS] and press [CH, W, X] several times to select DC
channel.
≥Contrary to DC channel, TP channel is the channel for DVD to
receive the video/audio signal from VHS. (l 59)
≥When the “TP” channel is selected on DVD, you cannot select
the “DC” channel.
VHSDVD
75VGN.book 61 ページ ２００４年７月２１日 水曜日 午前１１時５４分