Filter
Top Products
D-Link ShareCenter Pulse User Manual
Page 69
Standard, JBOD, RAID 0 and RAID 1. This section covers
the RAID 1 configuration.
RAID 1 mirrors the hard drives for redundancy. If one
hard drive fails, the other still has all of the data. Replace
the failed hard drive and it will re-mirror, restoring
maximum data protection. Click ‘’.
Auto-Rebuild is a feature that will allows the ShareCenter
Pulse to initiate the Rebuilding phase automatically. The
Rebuilding phase will occur when one or more hard
drives fail and is replaced by a new one. Click ‘’.
- This feature will automatically format the
newly added drive. If this feature is NOT required, click
disable.
In this section the user can view the available capacity
that RAID 1 can use on the hard drives installed.
Then the user can configure the desired capacity to be
used for the RAID 1 configuration by entering the desired
capacity amount in the block provided.
To utilize the remaining space, (if the two HDDs differ
in capacity), the user can choose to use JBOD for the
remaining space. Tick this option is needed. Click ‘’.
In this section a summary of the configuration will be
displayed. When ready click on the ‘’ button to
initiate the RAID configuration. This process will involve
initializing, formatting and configuration of the RAID
chosen.
A warning message will be displayed before the procedure starts
stating that hard drives will be formatted and if the user wishes to
continue. Click ‘’ to continue.