Filter
Top Products
D-Link ShareCenter Pulse User Manual
Page 10
5. Connect an Ethernet cable to the available Ethernet port. This cable should
connect the ShareCenter Pulse to your local network via a router or switch, or
directly to a computer for configuration.
Make sure to align the drive connector to the SATA connector on the bottom edge inside the drive bay of the ShareCenter Pulse. Gently push the drive in until it connects.
When a drive is inserted properly, you will feel it “seat” into the connector. Some hard drives that are thin or oddly shaped may need to be guided carefully into position. If a
drive is not properly seated, the light will not illuminate after powering on the device.