Filter
Top Products
D-Link ShareCenter Pulse User Manual
Page 44
Set the maximum amount of users that can connect to the
FTP server.
Set the amount of time a user can remain idle before
being disconnected.
Set the FTP port. Default is 21.
In situations where the device is behind a firewall and
unable to accept incoming TCP connections, passive
mode must be used.
Most standard FTP clients like Windows FTP, only
support Western European code page when transferring
files. Support has been added for non standard FTP
clients that are capable of supporting these character sets.
Allow you to limit the amount of bandwidth available for
each user.
Here the user can enable the SSL/TLS connection only.
ver. The server is easy to
configure and allows users access to important data whether they are on the local
network or at a remote location. The FTP server can be configured to allow user access
to specific directories, and will allow up to 10 users to access the ShareCenter Pulse
simultaneously.
In order to use FXP (File Exchange Protocol) for server-to-server data transfer, please make sure to change the port from 21 to some other port as listed in the
Port section of the web UI. Also, please make sure to open the corresponding port on your router and forward that port from your router to the ShareCenter
Pulse.