Filter
Top Products
119
GB
Troubleshooting
The “File Full” animation is
displayed and you cannot
operate the IC recorder.
• 199 files have been recorded in the selected folder ( ) or 4,074
files (when there are 21 folders) in total have been recorded.
Therefore you cannot record another file, or move a file. Erase
some of the files (page 27) or erase all the files after you store
them on the other memory media or on your computer.
You cannot record a file. • The remaining memory capacity is insufficient.
• You cannot record a file when you select a folder in the playback-
only area (the (Music) tab and the (Podcast) tab).
The playback volume is low. • The volume is turned down completely. Press VOL+ or – to adjust
the volume (page 23).
• The recording scene is set to (Voice Notes) or (Audio IN).
Select a recording scene depending on the current situation
(page 29).
• “Mic Sensitivity” is set to “Low .”Set it to “High ,” or
“Medium .” (page 78).
Recording is interrupted. • The VOR function is activated. Set “VOR” to “OFF” in the menu
(page 34).
The VOR function does not
work.
• During synchronized recording, the VOR function does not work
(page 41).
• During FM recording, the VOR function does not work (for
ICD-UX512F only).
When recording from other
equipment, the input level is
too strong or not strong
enough.
• Connect the headphone jack of other equipment to the
m (microphone) jack of the IC recorder and adjust the volume
level on the piece of equipment connected to the IC recorder.
Playback speed is too fast or
too slow.
• The playback speed is adjusted in DPC. Slide the
DPC(SPEED
CTRL) switch to “OFF” or press v or V on the control button to
adjust the speed in DPC again (page 46).
Symptom Remedy