Filter
Top Products
Chapter 2 Operation and Maintenance
64
iSM13224: MV is restored.
Volume Name: mount point volume name
Mount Point: drive letter or NTFS folder path name
Step 2. Re-setting the drive letter and remounting MV into the NTFS folder
Start [Disk Management]. According to the collected MV volume information (drive letter and
mount point volume name), operate the volume with [Change Drive Letter and Path] to set the
drive letter and mount the MV with the NTFS folder path name specified.
You can also set the drive letter and mount the MV in the NTFS folder by entering the
MOUNTVOL command through the command prompt.
Example of setting a drive letter
To set the drive letter H for the volume under the mount point volume name
“\\?\Volume{37d84cca-2507-11d5-a0f7-00004c714491}\”, specify as shown below.
MOUNTVOL H: \\?\Volume{37d84cca-2507-11d5-a0f7-00004c714491}\
Step 3. Repairing the file system
The file system may contain conflicting data. Execute CHKDSK /F to repair the file system.
Example of executing CHKDSK
Omit the “\” at the end of the mount point volume name in specifying it for CHKDSK.
CHKDSK \\?\Volume{37d84cca-2507-11d5-a0f7-00004c714491} /F
* For notes on executing CHKDSK, refer to the help information of CHKDSK.
(3) Illegal File System on RV Connection Server
Replication operation without unmounting RV may result in illegal file system.
If RV file system has become illegal, restore the system by the restoration procedures.
Research method
• When an error occurs in using the ReplicationControl or an access program.
If the ReplicationControl command outputs the following error message or errors meaning
“destroyed file or disk”, the RV file system is illegal. Restore the file system by the
restoration procedures.
iSM13639: Specified path is not normal status.
• If backup server is allowed to access RV during replication or unmounting operation
* Normally, access to RV during replication operation or unmounting operation with
automatic mounting suppressed on Windows 2000 is not allowed because RV is in the Not
Ready state.
Try access to RV volume during replication or unmounting operation from My Computer.