Filter
Top Products
Chapter 2 Operation and Maintenance
49
The following describes the procedure for executing replication control for the RV that is can be used
as a file system through the prepared volumes:
Step 1. Terminating applications (backup server)
To maintain data consistency, terminate or halt applications and specified services that area accessing
the volume concerned.
(Example) Stopping service
NET STOP (service name)
To stop the service “ESMCommonService”, specify as shown below.
NET STOP ESMCommonService
Step 2. Flushing RV file system (backup server)
Flush the file system of RV and write data in buffer of the file system which has not been written to the
disk.
iSMrc_flush –drv H:
Then, the following message is displayed and flush is executed.
Flush Start 2001/02/21 11:21:13
disk11 dev002 WN
\\?\Volume{37d84cca-2507-11d5-a0f7-00004c714491}\
H:
Flush Normal End 2001/02/21 11:21:13
disk11 dev002 WN
\\?\Volume{37d84cca-2507-11d5-a0f7-00004c714491}\
H:
Step 3. Unmounting RV (backup server)
Unmount RV and cancel association between the volume and the file system.
When the RV is unmounted, the mount point (drive letter or NTFS folder name) set for the volume is
automatically deleted. On Windows 2000, the RV access restriction is changed to Not Ready.
* Set NOTREADY for the UMOUNT_RVACC parameter in the replication operation option setting
file to suppress automatic RV mounting before operation.
Step 12. Restarting applications
Step 11. Mounting RV
Step 10. Restarting applications