Filter
Top Products
Chapter 1 Installation Procedure
27
Upon successful creation of Volume List, the following message appears:
iSMvollist: Info: iSM11701: Volume list is created successfully.
Output the Volume List data into the vollist_data.txt.
iSMvollist -a > vollist_data.txt
* If a logical disk name has been changed using the iSM, the Volume List must be updated.
* To use a control volume, before creating a Volume List, select and register the control volume using
the Define Control Volume function from the Volume List Display screen.
Step 15. Researching mount point volume name
A mount point volume name used for operation must be researched.
Enter “MOUNTVOL /L” on DOS prompt.
MOUNTVOL /L
Then, the list of volumes available on system is displayed as follows:
\\?\Volume{e2464851-8089-11d2-8803-806d6172696f}\
F:\
\\?\Volume{e2464852-8089-11d2-8803-806d6172696f}\
G:\
\\?\Volume{e2464850-8089-11d2-8803-806d6172696f}\
H:\
A mount point volume name is required for replication operation for operations such as backup, etc.
Take a memo of the mount point volume names, which are displayed in the mount point volume name
list, to use in the operation.
Now, the volume is ready.