Filter
Top Products
MAINTENANCE - 66 -
Center.
Playback picture is
partially noisy.
• The tracking control is not
set correctly.
• Adjust tracking control for
a better picture.
On-the-air TV programs
cannot be seen.
• Connections are not
correctly made.
• The TV and/or VCR is in
VCR mode.
• Re-check the ANT.IN and
A
NT.OUT connections.
• Set your TV to the TV
mode and/or press VCR/TV
button on the remote control
so that "VCR" disappears
from the display.
No operation by
infrared Remote
Control.
• Weak batteries.
• The TV or CATV button is
pressed.
• Check the batteries in the
remote control.
• Press VCR button on the
remote control, then try
again.
Operation buttons do
not work after there is a
power failure or you
move your VCR.
• Channel Memory
Programming is required
because programmed
channels are erased.
• See "NOTES" under
"AUTOMATIC CHANNEL
PRESET" on page 14.
MAINTENANCE
SERVICING
Should your VCR become inoperative, do not try to correct the problem by
yourself. There are no user-servicable parts inside. Turn off, unplug the
power cord, and take the unit to Authorized Service Center for servicing.
CABINET CLEANING
• Wipe the front panel and other exterior surfaces of the VCR with a soft
cloth immersed in lukewarm water and wrung dry.
• Never use a solvent or alcohol. Do not spray insecticide liquid near the
VCR. Such chemicals may cause damage and discoloration to the
exposed surfaces.
HEAD CLEANING
Playback picture may become blurred or interrupted while the TV program
reception is clear. Dirt accumulated on the video heads after long periods
of use, or the usage of rental or worn tapes can cause this problem. If a
streaky or snowy picture appears during playback, the heads of your VCR
may need to be cleaned.
1. Please visit your local Audio/Video store and purchase a good quality
VHS Video Head Cleaner.
2. If a Video Head Cleaner does not solve the problem, consult the
nearest Authorized Service Center. Professional video head cleaning
requires highly technical attention.