Filter
Top Products
PRESET FOR USE - 32 -
Press POWER button to turn off the VCR for searching the local PBS
station. The power must remain off during this search.
If you enter the channel number manually at step 5,
• It may take about a few minutes for this search to be completed.
If you choose AUTO at step 5,
• The VCR will search through all the available channels from the lowest
channel. It must scan each channel for one minute to determine if that
channel is transmitting the EDS signal. If the highest channel has EDS
signal, it takes many times. You can start this channel search at night
when the unit is not in use.
• If the time that is automatically set by this selected PBS station is
incorrect, it may not be your local PBS station, but one from a different
time zone. Or there is a possibility that no channel is broadcasting the
EDS signal in your area, as shown by no time being set even after an
overnight search. In these cases, you must manually enter the correct
local PBS station, or set the clock manually, turning off the Auto Clock
Setting feature.
MANUAL CLOCK SETTING
We suggest that you use a TV or radio station as your time source.
In the example below, the clock is to be set to:
DATE 1st March, 1996
SETTING TIME 5:40PM
NOTE: You must use the remote control for this procedure.
Make sure...
• VCR power must be turned on.
• Turn on the TV and set the TV channel to the same video output channel
as located on the back of the VCR. (CH 3 or 4)
• Press VCR/TV button on the remote control so that "VCR" appears on
the display.
1 Select the main menu
Press MENU button.
2 Select "INITIALIZE"
Press CH/SET or button repeatedly to point to "INITIALIZE".
Then, press SELECT button.
MENU
TIMER PROGRAMMING
VCR SET UP
INITIALIZE