Filter
Top Products
SETTING THE REMAINING TIME - 59 -
Notes:
• Set the tape remainder switch ("~T60", "~T130" or "T140~") to the tape loaded.
See "Setting the Remaining Time" on next page.
• Even if SLP mode is selected, just-in time recording cannot compensate for a
tape length which may be too short.
• A momentary picture break up will occur at the point on the tape when the
recording speed changes from SP to SLP.
• The displayed remaining tape running time may not always match the actual
remaining time on the tape (usually longer than the actual time). It is
recommended to set the end of the reserved recording time several minutes after
the end of the TV program.
SETTING THE REMAINING TIME
You can set the remaining tape running time of your tape. Follow the steps
below to correct the tape remaining indication.
Make sure...
• VCR power must be turned on.
• Turn on the TV and set the TV channel to the same video output channel
as located on the back of the VCR. (CH3 or 4)
• Press VCR/TV button on the remote control so that "VCR" appears on
the display.
• You must use the remote control for the following procedure.
• A video cassette must be inserted in the VCR for this function to work.
1 Select the main menu.
Press MENU button.
2 Select "VCR SET UP"
Press CH/SET
or button repeatedly to point to "VCR SET UP".
Then, press SELECT button.
MENU