Filter
Top Products
TROUBLESHOOTING GUIDE pg. 36 - 65 -
Jerrold 1 1
Jerrold 2 2
Jerrold 3 3
Hamlin 4
Zenith 5
Scientific Atlanta 6
Pioneer 7
Philips 8
TO OPERATE THE CABLE BOX ONCE THE REMOTE IS
PROGRAMMED FOR IT.
1 Press CATV and then the button of the function you want.
2 Press VCR button to operate your VCR with the remote again.
TROUBLESHOOTING GUIDE pg. 36
If you have followed the instructions contained in this manual and have
difficulty in operating your VCR, locate the SYMPTOM in the left column
below. Check the corresponding POSSIBLE CAUSE and CORRECTIVE
ACTION columns to remedy the problem.
SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION
No power. • Power cord is not
connected.
• The VCR power is turned
off.
• Connect power cord to AC
outlet.
• Press POWER button to
turn on the VCR.
Timer recording is not
possible.
• The timer recording is set
incorrectly.
• The VCR power is turned
on.
• VCR clock is not set
correctly.
• Set the timer recording
correctly.
• Press POWER button to
turn off the VCR.
• Set VCR clock correctly.
Recording mode cannot
be engaged.
• The erase prevention tab
on cassette is missing.
• Place a plastic tape over
the hole.
No picture or poor
picture on playback.
• The TV and/or VCR is in
the TV mode.
• The TV fine tuning is not
set correctly.
• Set your TV to the the
VCR mode and/or press
VCR/TV button on the
remote control so that
"VCR" appears on the
display.
• Fine tune your TV.
Noise in picture on
playback.
• Video heads are dirty. • Head cleaning is
necessary, consult the
nearest Authorized Service