Filter
Top Products
18
Basic operation in all menus
• Use ARROW keys to select value or submenu
• Use ENTER to enter menus or for confirmation, and to
activate
• Use EXIT to step to a higher level or to decline an
operation
• Values are marked with an “ * “ when they can be altered
via the ARROW keys
Main Display
The Main Display indicates the position of the monitor
(when set up) and the set volume for the monitor.
A “+” indicates that this specific Master Unit has been set
up to act as System Controller.
Bass Management
Bass management is possible in:
- Standard Stereo with 1 Sub
- Standard Stereo with 2 Subs
- 5.1 Analog
- 5.3 Analog
- 6.1 Analog
- 6.1 Digital - at 192kHz
- 5.3 Digital
- 5.1 Digital/6 Master
- 5.1 Digital - at 192kHz
Satellite monitors uses 2nd order Hi Pass filters to
attenuate frequencies below the set Cross-over frequency.
Subs use 4th order Low Pass filter to attenuate frequencies
above the set Cross-over frequency.
• Press ENTER to access the Select Mode
Of
f:
Bass Management is not activated. Only the LFE channel
is distributed to the Sub.
AIR PC-IP
Via AIR PC-IP and advanced Bass Management mode is
available. In this mode all filters (Satellite, Sub4 and Sub2)
can be controlled to suit demanding setups.
PARAMETER DESCRIPTION
Menu Name
X-Over 50 Hz
X-Over 80 Hz
Extension 50 Hz
Extension 80 Hz
THX Sim 80 Hz
Small Cons 120 Hz *
Satellite filter
50 Hz
80 Hz
Off
Off
80 Hz
120 Hz
Sub 4th order
50 Hz
80Hz
50 Hz
80 Hz
80 Hz
120 Hz
Sub 2nd order
50 Hz
80Hz
50 Hz
80 Hz
Off
80Hz
LFE = Sub
No
No
No
No
Yes
Yes
Note that the Extension 50 and 80Hz uses no Bass Management on satellite speaker thus playing full range.
* Small Cons - Small Consumer
Cross-over frequencies: