Dynaudio Air Series Portable Speaker User Manual


 
12
SETUPS
To set a Master
monitor as
System Controller
the TC Link
button on the rear
panel MUST be in
out-position.
5.1 Digital - 192 kHz
This is a 5.1 digital setup at 192kHz with Bass
Management as an option. The setup requires three
Master monitors with the optional Digital I/O card
installed, two Slaves and one Sub.
Left monitor is set as System Controller by leaving out
the TC Link button on the rear panel.
- Left monitor receives Left and Right Front channels.
- Center monitor receives Center channel and Sub.
- Left Rear monitor receives LS and RS channels.
The Sub receives signal via TC LINK RJ-45 connections
from the Center Master monitor.
Clock MUST be sent on the AES connection feeding
Center/LFE channels (or on BNC).
With Bass-management “off” only the LFE signal is fed to
the Sub.
With Bass-management activated, Low Frequency
information below the set Cross-over frequency from the
5 main channels is extracted and distributed to the Sub
where it is summed with the LFE channel.
The Remote, AIR Soft and AIR PC-IP can be connected
to any available TC LINK Out connection.
To set a Master
monitor as
System Controller
the TC Link
button on the rear
panel MUST be in
out-position.
6.1 Digital - 192 kHz
This is a 6.1 digital setup with Bass Management as an
option. The setup requires four Master monitors with
the optional Digital I/O Card installed, two Slave
monitors (or Masters set as Slave) and one Sub.
Left monitor is set as System Controller by leaving out
the TC Link button on the rear panel.
- Left monitor receives both Left and Right Input signals.
- Right monitor receives signal via the TC LINK cable.
- Left Surround, receives both Left and Right surround
signals.
- Right Surround, receives signal via the TC LINK cable.
- Center receives both Center and Sub signals.
- The Sub receives signal via the TC LINK cable.
- Center Surround receives Center Surround channel.
Clock MUST be sent on the AES connection feeding
Center/LFE channels (or on BNC).
With Bass-management “off” only the LFE signal is fed to
the Sub.
With Bass-management activated, Low Frequency
information below the set Cross-over frequency from the
6 main channels is extracted and distributed to the Sub
where it is summed with the LFE channel.
The Remote, AIR Soft and AIR PC-IP can be connected
to any available TC LINK Out connection.