Filter
Top Products
Using the Metronome Function
ZOOM H2
68
screen comes up.
At this screen, you can specify whether to play
a pre-count before recording or playback. The
following settings are available.
●
OFF
No pre-count.
●
1 - 8
Play the specified number of beats as a pre-
count.
●
SPECIAL
Play a special pre-count pattern as shown
below.
Move the cursor to one of the items and press
the
5
(REC) key. The change is accepted
and the METRONOME screen appears again.
HINT
• The pre-count can be used also when the
metronome is set to OFF.
• When the auto record or pre-record function
is set to ON, pre-count settings cannot be
made.
5.
Specify the metronome tempo.
On the METRONOME screen, move the
cursor to "TEMPO" and press the
5
(REC)
key to bring up the METRONOME TEMPO
screen.
This screen lets you set the tempo of the
metronome in the range from 40.0 to 250.0
(BPM), in steps of 0.1 units.
Use the
3
(REW)/
2
(FF) keys to select the
tempo value and then press the
5
(REC) key.
The setting is accepted and the
METRONOME screen appears again.
HINT
• For any item, you can return to the
METRONOME screen without making a
setting by pressing the
4
(MENU) key
instead of the
5
(REC) key.
• If you start the playback before step 1, you
can set the tempo while listening to the
metronome sound. However, turning the
metronome on or off is not possible while
the recorder is operating, therefore you must
turn the metronome on first from the top
screen.
6.
Return to the top screen.
Repeatedly press the
4
(MENU) key until
the stereo mode or 4-channel mode top screen
appears again.
Glossary
BPM (Beats per Minute)
Indicates the number of quarter notes that are played in one minute.
H2-E.fm 68 ページ ２００７年７月１１日 水曜日 午後３時１９分