Filter
Top Products
Connecting the H2 to a Computer
ZOOM H2
75
HINT
To cancel the setting and return to the
previous screen, press the
4
(MENU) key
without pressing the
5
(REC) key.
NOTE
Be sure to set the sampling frequency of the
H2 to the same value as used by the
computer. If the setting is different,
communication with the computer cannot be
carried out normally.
6.
Return to the top screen.
Repeatedly press the
4
(MENU) key until
the stereo mode or 4-channel mode top screen
appears again.
NOTE
When the unit was started on USB power, you
cannot return to the screen before the AUDIO
I/F screen of step 4. To return to the top
screen, disconnect the USB cable to turn
power off, and then set the [POWER] switch of
the H2 to ON to start it up normally.
Enabling audio interface functions
To use the H2 as an audio interface, proceed
as follows.
1.
Connect the [USB] port of the H2
to a USB port on the computer,
using a USB cable.
If you connect the [USB] port to the computer
while the H2 is off, the H2 can be started on
USB bus power. In this case the USB menu of
step 3 comes up automatically and you can
skip steps 2 and 3.
2.
Bring up the main menu screen.
At the stereo mode or 4-channel mode top
screen, press the
4
(MENU) key.
3.
Bring up the USB screen.
Repeatedly press the
3
(REW)/
2
(FF)
keys to move the cursor to "USB" and press
the
5
(REC) key.
4.
Bring up the USB AUDIO I/F
screen.
Use the
3
(REW)/
2
(FF) keys to move the
cursor to "AUDIO I/F" and press the
5
(REC) key.
5.
Have the H2 recognized by the
computer.
Use the
3
(REW)/
2
(FF) keys to move the
cursor to "CONNECT" and press the
5
(REC) key. The USB AUDIO I/F screen
appears.
When this screen is shown, the H2 has been
recognized as an audio interface by the
computer. The level meters in the center of the
screen show the input level during recording
and the output level during playback.
HINT
To perform audio signal input/output via the
H2, you must also make an appropriate audio
interface selection at the computer.
For details, refer to the software used on the
computer.
6.
Select the input source and
make settings for input
sensitivity and recording level.
Level meters
H2-E.fm 75 ページ ２００７年７月１１日 水曜日 午後３時１９分