Filter
Top Products
Administrator Guide
39
Monitoring for the appropriate sensor is turned on.
To disable monitoring
1. Click Maintenance.
2. Click Monitoring tab.
3. Pick the desired sensor from the tree on the left.
4. Uncheck the Enable monitoring checkbox.
5. Click Set.
Monitoring for the appropriate sensor is turned off.
To set specific description label for any sensor
1. Click Maintenance.
2. Click Monitoring tab.
3. Pick the desired sensor from the tree.
4. Type description into the appropriate field on the right.
5. Click Set.
To fix the status of newly-inserted disk
1. Click Maintenance.
2. Click Monitoring tab.
3. Pick the desired disk sensor from the tree.
4. Click Fix on the right.
The status of a disk should change to Ok.