Filter
Top Products
Masterpage:Right0
EN 67
Filename [DVM70S_12Editing.fm]
Page 67 Friday, 6 May 2005 12:06
REMOTE CONTROL
Remote Control 1/2/3/4 Code Switching
The remote control is capable of controlling four JVC video units
independently. Each of the units can respond to one of the four
codes (1, 2, 3 or 4). The remote control is preset to send code 3
signals because your unit is initially set to respond to code 3
signals. You can easily modify your unit to respond to code 1, 2 or
4 signals.
● Keep pressing SET UP down during step 1.
1 Press the number key A1B for 1, A2B for 2, A3B for 3 or A4B for 4 to
change the remote control code, then press ENTER.
2 Press A on the unit to turn off the unit.
3 Press I on the unit for over 5 seconds while the unit is turned
off. The code currently set appears on the front display panel.
4 Press o on the remote control to change the unit’s code. The
code currently set on the remote control blinks on the front
display panel for approximately 5 seconds, and is applied to the
unit.
NOTE:
When APOWER SAVEB is set to AONB (A pg. 72), it is not possible
to change the remote code.
TV Multi-Brand Remote Control
Your remote control can operate the basic functions of your TV set.
In addition to JVC TVs, other manufacturer’s TVs can also be
controlled.
IMPORTANT:
Although the provided remote control unit is compatible with JVC
televisions, as well as many other models, it may not work with
your TV, or in some instances, may have limited function
capability.
● Keep pressing SET UP down during step 1.
1 Enter your TV’s brand code using the number keys, then press
ENTER.
2 Press A on the unit’s remote control to turn on the TV and try
operations (A step 3).
● Once you have set the remote control to operate the TV, you do
not have to repeat this step until you replace your remote
control’s batteries.
● Some brands of TVs have more than one code. If the TV does
not function with one code, try entering another.
3 Press the corresponding buttons to operate the TV: A,
TV/VIDEO, CH +/-, TV VOL +/–, TV, number keys.
● For some brands of TVs, you must press ENTER after having
pressed the number keys.
Remote Control Functions
● Slide the TV/CABLE/DBS/DVD switch to DVD.
I
A
ENTER
SET UP
o
1 – 4
CABLE/DBS
DVDTV
● Turn off the TV using its remote control.
● Slide the TV/CABLE/DBS/DVD switch to TV.
TV VOL +/-
0 – 9
TV / VIDEO
A
TV MUTING
CH +/-
SET UP
ENTER
CABLE/DBS
DVDTV
DVM70S_00.book Page 67 Friday, May 6, 2005 12:06 PM