Filter
Top Products
Masterpage:Right0
EN 41
Filename [DVM70S_08DV Operation.fm]
Page 41Friday, 6 May 2005 12:06
BASIC OPERATIONS ON DV DECK
1 Load a cassette. Make sure the window side is up, the rear
label side is facing you and the arrow on the front of the
cassette is pointed toward the unit.
● Do not apply too much pressure when inserting.
● If the erase protection switch is set to ASAVEB, playback begins
automatically. It takes about 15 seconds until the playback
picture appears. However, when APOWER SAVEB is set to
AONB (A pg. 72), playback will not begin automatically even
though a cassette with its erase protection switch set to ASAVEB
is inserted.
● The unit’s power comes on automatically.
2 Press DV/HDD/DVD on the unit repeatedly or DV on the remote
so that the DV lamp lights up on the unit.
3 Find the program start point. If the tape is advanced past the
start point, press O. To go forward, press N.
4 Press I to start playback.
5 Press o to stop playback.
● To eject the cassette, press M (DV).
NOTE:
When you record a tape on the DV deck with the recording speed
set to ALPB, it is recommended to play back that tape back on this
DV deck. Digital video recorder from other manufacturers may not
be able to play back the tape properly.
Basic Playback
● Turn on the unit.
● Turn on the TV and select the AV mode.
● Slide the TV/CABLE/DBS/DVD switch to DVD.
DV/HDD/DVD I
M
o
O
N
DV
o
N
O
o
CABLE/DBS
DVDTV
Clean the video heads using a dry cleaning cassette
- M-DV12CL - when:
● No picture during playback.
● Block noise appears during playback.
● AUSE CLEANING CASSETTEB appears on the screen.
NOTE:
The heads get dirty in the following cases:
● in an environment prone to extreme temperature or humidity
● in a dusty environment
● flaw, dirt or mould on video tapes
● continuous usage for a long time
Usable cassettes
● Cassettes marked P can be used with the DV deck.
● Tapes recorded in the DVCAM format can be played.
Accidental erasure prevention
To prevent accidental recording on a recorded cassette, set its
erase protection switch to ASAVEB. To record on it later, set the
switch to ARECB.
Erase protection switch
DVM70S_00.book Page 41 Friday, May 6, 2005 12:06 PM