Filter
Top Products
Filename [DVM70S_12Editing.fm]
Masterpage:Left+
66 EN
EDITING
Page 66 Friday, 6 May 2005 12:06
Insert Editing replaces the pictures with new ones, while the audio
soundtrack remains unchanged. For Insert Editing, use your unit
as the recording deck.
1 Make connections.
A If the player has no S-VIDEO output connector:
^ connect the player’s AUDIO/VIDEO OUT connectors to your
unit’s [VIDEO/AUDIO ((MONO) L/R)] input connectors on
the front panel.
B If the player has an S-VIDEO output connector:
^ connect the player’s AUDIO OUT and S-VIDEO OUT
connectors to your unit’s [AUDIO] and [S-VIDEO] input
connectors on the front panel.
2 Load a Mini DV cassette with the erase protection switch set to
ARECB.
3 Press DV/HDD/DVD on the unit repeatedly or DV on the remote
so that the DV lamp lights up on the unit.
4 Press CH +/- to select AF-1B.
5 Press S, T and W to determine the edit-in point (the
beginning of the segment to be replaced).
● Be sure to engage the Still mode at the edit-in point.
6 Press INSERT to engage the insert editing mode.
● Your unit enters the Insert Pause mode.
● The TV screen changes from the still picture to the input source
you are going to record.
7 Load the source cassette and play back the segment that is to
be inserted. When you reach the start of the section of the
source tape that you wish to insert, press I to start the tape in
your unit. Insert editing begins at this point.
8 Press o to stop recording on the DV deck to end insert editing.
NOTES:
● Once the Insert Editing starts, you cannot use the other deck.
● All necessary cables can be obtained from your dealer.
● Insert Editing cannot be performed on a Mini DV cassette that
has had its erase protection switch set to ASAVEB.
● When Insert Editing is performed on a tape that has been
recorded on another video recorder, the inserted portion may
appear distorted.
● A small portion of the recording which precedes an insert edit
may become erased.
● Insert Editing is not possible using the [DV IN/OUT] connector.
● Insert Editing is not possible on a blank portion of the tape.
Insert Editing (DV Deck Only)
ATTENTION:
Insert Editing is not possible with a Mini DV cassette recorded in
LP mode.
AUDIO/VIDEO OUT
Audio/video
cable
(not supplied)
Recorder
To [VIDEO/AUDIO
((MONO) L/R)] input
Your unit
INSERT
Recorder
Your unit
To [AUDIO] input
A If the player has no S-VIDEO output connector:
B If the player has an S-VIDEO output connector:
Another recorder
Another recorder
Player
Player
Audio cable
(not supplied)
AUDIO OUT
S-VIDEO
OUT
S-video cable
(not supplied)
To [S-VIDEO]
input
CH +/-
CH +/-
INSERT
●
Slide the TV/CABLE/DBS/DVD switch to DVD.
DVM70S_00.book Page 66 Friday, May 6, 2005 12:06 PM