Filter
Top Products
JUST-IN TIME RECORDING
37
RETURN button on the VCR first. The VCR will rewind to the beginning of the recorded
program(s).
NOTE: If there are any remaining timer programs, press POWER button to turn on, then press
AUTO RETURN button. But in this case, if you press any other button once and press AUTO
RETURN button, the Auto Return will not be done.
USING THE MENU
If you select auto return to [AUTO] from the menu, when all the timer recordings are
completed, the VCR will rewind to the beginning of the recorded program(s) without pressing
AUTO RETURN button.
Make sure... If there are any remaining programs including Daily & Weekly, this function
will not be done.
1 Press MENU button on the remote control repeatedly so that the VCR SET UP menu
appears.
2 Press the PLAY/ or STOP/ button to point to AUTO RETURN".
3 Press the F.FWD/ button so that [AUTO] will appear next to "AUTO RETURN".
4 Press MENU button on the remote control to return to original mode.
NOTE: To exit the auto return programming, repeat steps [1] to [2]. Then, press the F.FWD/
button. [AUTO] will then disappear from the menu. Press the RESET/EXIT button to return to
TV mode.
WATCH THE RECORDED PROGRAM
Press the POWER button to turn on the VCR. Then, press the PLAY button.
JUST-IN TIME RECORDING
This function allows you to fully utilize the available tape length for timer recording. The VCR
calculates the remaining tape amount and then adjusts the tape speed from SP to SLP as
needed.
If it is suspected that the end of the tape will be reached before the reserved program ends (as
long as SP mode is kept all the way), set recording mode to AUTO. This function is available
only with Program No. 1 and (Timer Recording).
The AUTO mode starts recording in SP mode. The internal circuit compares the rest of the
program against the available tape length. If the internal circuit determines that the available
tape is not long enough to record the program in the SP mode, the Recording mode is
automatically changed to SLP mode. This will assure coverage of the desired timer program
before the end of the tape is reached.