Filter
Top Products
PREPARATION FOR USE
13
PREPARATION FOR USE
CABLE CONNECTIONS
For some of the most common types of connections, see the following drawings. Use only one
connection. For any further complex connections, please contact your local dealer or other
qualified persons. (You may need additional accessories which are not supplied).
1 Disconnect the antenna or cable from your TV.
2 Connect the antenna or cable to the ANT. IN jack of your VCR.
3 Connect one end of the coaxial cable (supplied) to the ANT.OUT jack of your VCR.
4 Connect the other end of the coaxial cable (supplied) to the UHF/VHF antenna jacks.
SETTING A VIDEO CHANNEL
If your TV does not have A/V terminals;
When the VCR is in the Playback mode or when the VCR is in the VCR position, your TV will
receive the signals from the VCR on either channel 3 or 4.
To use the VCR with your TV, set the selector switch to CH3 or CH4, whichever is not used or
least used for normal broadcasts in your area. Then set your TV to that same channel.