Filter
Top Products
SETTING THE CLOCK
16
Press VCR/TV button on the remote control so that the "VCR" indicator appears on the
display.
5 Select 'ENGLISH" or "ESPANOL"
Select "ENGLISH" or "ESPANOL"=Spanish by using the PLAY/ or STOP/ button. Then,
press the MENU or F.FWD/ button.
6 Begin Channel preset
Press the MENU, F.FWD/ or REW/ button once. The tuner scans and memorizes all active
channels in your area.
• The VCR distinguishes between standard TV channels and cable channels.
7 After scanning
The tuner stops on the lowest memorized channel. The TV screen returns to TV mode.
• If "TUNER SET UP'. appears on the TV screen again, check the cable connections. Press
the MENU, F.FWD/ or REW/ button once again and the VCR will begin preset again.
TO SELECT A DESIRED CHANNEL
You can select the desired channel by using the CHANNEL or button or directly
pressing the number buttons on the remote control.
Note for using the number buttons:
• When selecting cable channels which are higher than 100, press the 100/ENT button first,
then press the last two digits. (Example: to select channel 125, first press the 100/ENT button
then press "2" and "5").
• You must precede single-digit channel numbers with a zero (For example: 02, 03, 04 and so
on).
SETTING THE CLOCK
Set the clock accurately for proper automatic timer recording. We suggest that you use a TV or
radio station as your time source.
In the example below, the clock is to be set to:
DATE March 1st, 1997
SETTING TIME 5:40PM
Make sure...
· You must use the remote control for this procedure.
· VCR power must be turned on.
· Turn on the TV and set the TV channel to the same video output channel as located on the
back of the VCR. (CH 3 or 4)
· Press VCR/TV button on the remote control so that the "VCR" indicator appears on the
display.
1 Select "SETTING CLOCK"
Press the MENU button. The SETTING CLOCK menu appears.
Make sure...
· When you press the F.FWD/ button during steps [2] to [6], you may move forward to the