Filter
Top Products
AUTOMATIC TIMER RECORDING
30
programs to record on specific days, daily or weekly within a 1 year period.
In the example below, the timer is being set to record:
DATE: May 6th, 1997
SETTING TIME: from 7:30PM to 8:30PM
CHANNEL: CH16
TAPE SPEED: SP
PROGRAM NO: No. 1
Make sure...
• You must use the remote control for this procedure.
• VCR power must be turned on to program it.
· Turn on the TV and set the TV channel to the same video output channel as located on the
back of the VCR. (CH3 or 4)
• Press VCR/TV button on the remote control so that the "VCR" indicator appears on the
display.
· Clock must be set to the correct time and date before setting the timer.
· Insert a cassette tape with its erase prevention tab in place. (If necessary, rewind or fast
forward the tape to the point at which you want to begin recording.)
Avoid overlap of programs ...
There is a case that a program will not be performed.
When programs overlap:
· The program with an earlier start time has priority.
· When the earliest program has finished and the programs which should start still overlap, the
recording will start in order of the program number.
· If you programmed as the illustration below, the timer recording would be carried out as
follows (shaded part is the carried period):
9:00am-10:00am for PROGRAM 2
10:00am - for PROGRAM 1
1 Select "TIMER PROGRAMMING"
Press the MENU button so that TIMER PROGRAMMING menu appears.
NOTE: If you have not yet set the clock, "SETTING CLOCK" appears. If so, follow the steps [2]
to [8] on page 13. Then, set the timer recording.
2 Select your desired program number (1-7)
Program number which is not set up flashes.
Press the PLAY/ or STOP/ button until your desired program number appears. (Example:
1)
Then, press the F.FWD/ button.