Filter
Top Products
110
Troubleshooting
This section provides tips on solving problems that may occur.
The recording only plays on the L channel (left)
• If using an external microphone, check whether the microphone is set to stereo or monaural. If
the microphone is a monaural one, only the L channel (left) is recorded.
To record both channels using a monaural microphone, set the microphone type to “MONO.”
“Setting the external microphone type (EXT Mic Type)” (p. 101)
Recording won’t start
• Check the amount of space available on the memory card.
Recording is impossible if there is less than 16 KB available. Recording standby cannot be
entered either.
“Estimated recording times” (p. 36)
Can’t use the microphone
• When using the [Internal MIC], do not connect anything to the other input jacks. If a
microphone, cable, or device is connected to the [MIC Input Jack] or [LINE IN Jack], the
[Internal MIC] cannot be used.
“MIC INPUT jack” (p. 11), “LINE IN jack” (p. 11),
“Using the internal microphones” (p. 37)
• When using an external microphone, please do not connect anything to the [LINE IN Jack].
If a microphone, cable, or other device is connected to the [Line In Jack], then the input from
the [MIC Input Jack] is ignored.
“MIC INPUT jack” (p. 11), “LINE IN jack” (p. 11),
“Using external microphones” (p. 41)
• When using an external microphone, make sure to choose the settings appropriate for the
microphone being used.
“Set the type of microphone being used.” (p. 43)
• Is a phantom powered microphone connected
?
The R-09HR does not support phantom powered microphones.
The recording is distorted
• Sound becomes distorted if the input level is too high. Set the input level to an appropriate
value.
“Adjusting recording levels” (p. 45)
Problems during recording
R-09HR_e.book 110 ページ ２００７年１２月１７日 月曜日 午後２時１６分