Filter
Top Products
103
R-09HR configuration settings
This sets the frequency to apply Low Cut when the [Low Cut Switch] is on.
fig.inputsetting-e.eps_80
1.
Select “Input Setup” from the [Menu
Screen].
Use the [PLAY Button ] and [STOP Button ] to select
“Input Setup,” and then press the [REC Button].
fig.limiterAGC-e.eps_80
2.
Select “Low Cut Freq.”
Use the [PLAY Button ] and [STOP Button ] to move
the cursor to the Low Cut Freq line.
fig.setlimiterAGC-e.eps_80
3.
Set the Low Cut Freq frequency.
Use the [PREV Button ] and [NEXT Button ] to change
the Low Cut value.
When finished with the settings, press the [MENU button] to return
to the previous screens, in order.
Setting the low cut frequency (Low Cut Freq)
Setting
100 Hz
200Hz
400Hz
Move the
cursor
up or down
Enter
Move the
cursor
up or down
Change
the value
R-09HR_e.book 103 ページ ２００７年１２月１７日 月曜日 午後２時１６分