CHAPTER
1-1
Catalyst 2955 Hardware Installation Guide
78-14944-03
1
Configuring the Switch with the
CLI-Based Setup Program
This chapter provides a command-line interface (CLI)-based setup procedure for
a standalone switch. For product overview information, see Chapter 2,
“Overview.” Before connecting the switch to a power source, review the safety
warnings in Chapter 3, “Installation.” For procedures on connecting the switch to
a power source, rack-mounting your switch, or connecting to the Ethernet ports,
see Chapter 3, “Installation.”
Caution If you are installing your switch in a hazardous environment, review the safety
warnings in Chapter 4, “Installation in a Hazardous Environment.” For
installation procedures for a hazardous environment, see Chapter 4, “Installation
in a Hazardous Environment.”
These steps describe how to do a simple installation:
1. Taking Out What You Need, page 1-2
2. Connecting to the Console Port, page 1-4
3. Starting the Terminal-Emulation Software, page 1-5
4. Connecting to a Power Source, page 1-2
5. Entering the Initial Configuration Information, page 1-6
