A SERVICE OF

logo

Chapter 3 Installation
Connecting the Switch to the Power Converter
3-36
Catalyst 2955 Hardware Installation Guide
78-14944-03
Follow these steps to prepare an AC power cord to connect to the power converter.
Warning
When installing the unit, always make the ground connection first and
disconnect it last.
Statement 42
Step 1 Cut off the female connector on the cord.
Step 2 Using a wire-stripping tool, strip the outer insulation layer 1 inch (2.54 cm).
Step 3 Strip the inner wire insulation to 0.25 inch (6.3 mm) ± 0.02 inch (0.5 mm), as
shown in Figure 3-15.
Figure 3-15 Preparing the AC Power Cord
1 0.25 inch (6.35 mm) 2 0.75 inch (19.05 mm)
104352
1
2