A SERVICE OF

logo

Open as PDF
next previous
4-45
Catalyst 2955 Hardware Installation Guide
78-14944-03
Chapter 4 Installation in a Hazardous Environment
Removing the Switch from a DIN Rail or a Rack
Removing the Switch from a DIN Rail or a Rack
To remove the switch from a DIN rail or a rack, follow these steps:
Step 1 Ensure that power is removed from the switch, and disconnect all cables and
connectors from the front panel of the switch.
Step 2 Push down on the top of the DIN rail clip release tab with your finger. As the clip
releases, lift the bottom of the switch, as shown in Figure 4-22 and Figure 4-23.
Figure 4-22 Removing the Switch from a Parallel Mounting Position
1 DIN rail clip 3 DIN rail clip release tab
2 DIN rail
104563
1
2
3