Filter
Top Products
Additional Information48
EN
Additional Information
Problem
Increase of noise or
deterioration of sound.
There is no sound.
The sound is distorted
through the
headphones.
The volume cannot be
adjusted.
Cannot rewind (AMS)
the tape.
The tape stops suddenly
during playback.
The clock displays
97Y11M1D/
AM12H00M00S.
Neither Start ID nor
PGM number can be
written.
The Start ID is written,
but the PGM number is
not written.
Operation buttons do
not work while the Start
ID is being written.
Absolute time cannot be
written.
The battery life has
become shorter
Charging does not start
(the CHARGE lamp does
not light up).
Cause
The head may be dirty.
Recording was not done
properly.
The volume is turned down
completely.
Incorrect operation of the
connected equipment.
The head may be dirty.
The volume is too loud.
The Hold function is on.
The Start ID is not written.
There is an unrecorded segment
on the tape.
The batteries were removed
from the unit for a long time.
The record-protect shutter on
the cassette is open.
When recording on a partially
recorded tape, the most recent
PGM number is not displayed
before recording.
While the Start ID is being
written, none of the buttons
except p STOP can be used.
Recording has been started
from an unrecorded segment of
the tape.
The battery life may shorten
excessively depending on the
temperature or the type of
battery.
You inserted the rechargeable
batteries in the battery charger
before plugging in the charger
to the wall outlet.
Solution
Clean the head with the cleaning
cassette.
•Clean the head with the
cleaning cassette and try again.
•Fast forward the tape to the
end first, and then rewind it to
the top before recording.
Press the + button of VOL to
adjust the volume.
Operate the connected
equipment as instructed in the
Operating Instructions manual.
Clean the head with the cleaning
cassette.
•Turn down the volume.
•Set AVLS to LIMIT (page 37).
Cancel the Hold function.
Write the Start IDs (page 30).
——
Set the clock again. (See page
13.)
Close the shutter on the cassette.
(See page 15.)
When recording on a partially
recorded tape, display the PGM
number before commencing
recording.
Press the buttons after the
indicator has stopped
flashing.
Rewind the tape to the
beginning, locate the end of the
previous recording and start
recording from that point. (See
page 16.)
Use the recommended NH-D100
battery.
Remove the rechargeable
batteries, then insert them again.